美文网首页
2019-01-07 EDVT measurement II

2019-01-07 EDVT measurement II

作者: Berry521 | 来源:发表于2019-01-07 20:46 被阅读6次

    Frequency Accuracy

    Specification
    For IEEE 802.11a 17.3.9.4
    ± 20ppm Maximum
    For IEEE 802.11b 18.4.7.4
    ± 25ppm Maximum (± 60kHz)
    For IEEE 802.11g 19.4.7.2
    ± 25ppm Maximum (± 60kHz)

    ESA Basic Setup
    -Span 50kHz
    -RBW 1kHz
    -VBW 1kHz
    -Sweep Time 50ms
    -Detector RMS Average

    EDVT Condition
    -Nominal Voltage +/- 10%
    3.0V, 3.3V, 3.6V
    Low,Room,High Temperature
    0C, 25C, 60C

    RF Carrier Suppression (IEEE802.11b)

    Carrier Suppression
    The Measure DC Offset for Single Chip Transceiver
    Abs |Center frequency Power – the Closed Peak Power|
    Specification
    For IEEE 802.11b 18.4.7.7
    QPSK Modulation with scrambling disable and repetitive 01 transmit pattern
    Minimum 15dB power below from the center frequency to the Closed Peak of Sin(x)/x Spectrum in SA
    SA Setting (5MHz Span, RBW 100kHZ, VBW 100kHZ, Sweep Time 500ms)
    For Draft IEEE802.11g-01/644r0 19.4.7.7.1
    Use Time Gate function at the short training from VSA to measure the power difference from the center frequency to the closed peak
    Minimum 15dB power below from the center frequency to the Closed Peak of Sin(x)/x Spectrum in VSA

    ESA Basic Setup
    -Span 5MHz
    -RBW 100kHz
    -VBW 100kHz
    -Sweep Time 500ms
    Detector RMS Average

    EDVT Condition
    -Nominal Voltage +/- 10%
    3.0V, 3.3V, 3.6V
    -Low,Room,High Temperature
    0C, 25C, 60C

    image

    相关文章

      网友评论

          本文标题:2019-01-07 EDVT measurement II

          本文链接:https://www.haomeiwen.com/subject/ccvprqtx.html