生物膜的Steady-state

作者: 代号北极能 | 来源:发表于2021-02-24 00:37 被阅读0次

在生物膜中存在着如下几个重要的过程。

1. 基质的扩散过程

J=\frac{D}{L}(S-S_0)=D_f\frac{dS_f}{dz}|_{z=0}=D_f\frac{dS}{dz}|_{z=0}

2.生物膜中基质利用方程

0=D_f\frac{d^2S_f}{dz^2}-\frac{qX_fS_f}{K+S_f}

3.生物膜中的活性生物组分变化

0=YJ-bX_fS_f

对于平衡状态下的生物膜应当同时满足以上三个方程。

解以上方程的前提是合理的选取下列参数。

\hat{q}

K

D_f

L

Y

b'

X_f

S

上图可以得到Steady-state的五个重要的趋势。

1. Steady-state状态下的生物膜损失速率biofilm loss rate等于生物膜的污泥龄SRT。 对于以某一个biofilm loss rate运行的系统来说,存在最低的基质浓度Sbmin, 可以通过下式计算

S_{bmin}=K\frac{b}{Y\hat{q}-b}=K\frac{b+b_{det}}{Y\hat{q}-(b+b_{det})}

对于CSTR来说,这个操作的基质浓度是维持生物膜SRT的最低基质浓度。因此这里的S_{min}S_{bmin}用不同的notation。如果b_{det}=0,S_{min}=S_{bmin}。With a CSTR, the effluent S value is the same at a given\theta_x regardless of the influent substrate concentration. In contrast with a biofilm reactor, increasing the influent substrate concentration causes the effluent value for S to increase over S_{bmin} The difference comes about because, in a CSTR, all microorganisms are exposed to the same S, while the concentration decreases with depth into a biofilm. As with any steady-state completely mixed biological process, having S lower than this critical level gives a negative growth rate and no possibility for sustaining steady-state biomass. Thus, S_{bmin} remains a very key factor for the design and operation of both systems.

2. J and X_fL_fincrease very sharply (on the logarithmic scale) as S increases slightly above S_{bmin}. This rapid escalation occurs because J andX_fL_f increases together. A small increase to S allows greater J, which allows greater X_fL_f, however, greater X_fL_f also increases J. Thus, the positive feedback among S, J, and X_fL_f, allows a very rapid increase in J for S slightly above S_{bmin}.

3. At some value of S > S_{bmin}, the slope of J versus S declines from near infinity and approaches 1.0. This occurs at approximately S = 0.07 mg/ cm3 for the example in Figure 7.3.

4. For S large enough, the flux becomes equal to that of a deep biofilm. The concentration S_{deep} signifies the spot, which is S approximately equal to 0.11 mg/cm3 in Figure 7.3. For all S\geq S_{deep} the steady-state biofilm is deep, or St approaches zero before the attachment surface. The practical significance of having a deep biofilm is that J no longer depends on X_fL_f because additional biomass does not increase the reaction rate (for the same S) when all of the added thickness has s1 = 0. On the other hand, J and Xf, increase for larger S, because the substrate concentrations inside the biofilm rise in response to a higher S.

5. For very large S, the slope of J versus S declines gradually and eventually reaches the limiting case of one-half-order kinetics, or J=k_{1/2}*S^{1/2}• Half-order kinetics is a well-known special case for deep biofilms; it is discussed later in this chapter. The practical impact of a reaction order less than one is that increases in S give less than proportional increases in J, and marginal increases in substrate removal go down when the system is operated well into the deep region.

相关文章

  • 生物膜的Steady-state

    在生物膜中存在着如下几个重要的过程。 1. 基质的扩散过程 2.生物膜中基质利用方程 3.生物膜中的活性生物组分变...

  • 关于K1的部分介绍

    移动床生物膜反应器(Moving Bed Bilfilm Reactor,MBBR) 又称悬浮填料生物膜工艺( S...

  • Steady-State Thermal

    稳态分析总 Ansys Workbench Import Systems 热稳定性模块 非线性热稳定性模块静态结...

  • 读书笔记:生物膜的生成与脱落

    生物膜随着对底物的分解从而获取了能量合成了自身,促使生物膜的增厚。 但随着厚度的增加,内层生物就难...

  • 读书笔记:可生物降解顺序

    针对不同的污染物,微生物对其的去除有难有易,虽然双膜理论中“吸收-生物膜”和“吸附-生物膜”很好地解释了对...

  • 读书笔记:“吸收-生物膜理论”与“吸附-生物膜理论”

    从文中初步可以知道,“吸收-生物膜理论”与“吸附-生物膜理论”分别对于“溶解性污染物”与“不溶或难溶污染物...

  • 读书笔记:生物膜厚度

    “生物膜过厚将不利于营养物质和氧气在生物膜内的传质。因此,在联合工艺生物过滤单元中,氯苯分子、营养物质和...

  • 生物接触氧化

    在生物膜法之中,如果按照污水是否浸没了反应器生物膜部分,可以分为浸没式、半浸没式和非浸没式,而生物接触氧化就...

  • 蛋白质的跨膜螺旋结构域预测(transmembrane heli

    膜蛋白分析:生物膜所含的蛋白叫膜蛋白,是生物膜功能的主要承担者。生物体大约30%蛋白质都是膜蛋白,而膜蛋白是药物的...

  • MBBR填料的判别指标

    1、生物膜的附着性 生物膜的附着能力-评价填料优劣的最重要指标生物附着量=受保护的表面积(与填料的设计运行状态构有...

网友评论

    本文标题:生物膜的Steady-state

    本文链接:https://www.haomeiwen.com/subject/bqodfltx.html