Enabling Objective #5
Removal/Intstall of LCD Monitor,WIRE Feed/BITS board ,EFo Box assembly
Replacement of LCD Monitor
Wire Feed/BITS Board Location
Wire Feed/BITS Board Removal
-Remove top panel cover screws(9x)
-Disconnect all electrical cables from wire Feed/BITS Board
-Remove top panel cover screws(9x)(Loose phiip screw, slide board to right to remove)
-Disconnect all electrical cables from Wire Feed/BITS Borad
-Locate and loose 1 screw that secures the board to the upper console base
EFO Box Assembly
-Up To 5000 VOLTS DC IS PRESENT WITHIN THE EFO BOX WHEN THE EFO FIRES
-DO NOT OPEN THE EFO BOX
-THERE ARE NO USER-SERVICEABLE COMPONENTS INSIDE THE EFO BOX
EFO BOX REMOVAL
Procedure:
- Turn off machine power,wait five minutes before continuing with the procedure
- Remove the top panel cover on upper console assembly to access the EFO box
- Locate the 3x M4x10mm SHCSs with washers on the underside of the upper console chasis and remove the screws
- Disconnect the following cables the EFO box:EFO Hight-voltage cable from connector J3(right side of box) power cable from cocnnector J6(near panel of box) Data cable from connector J2(real panel of box)
- Remove the EFO box from the machine.
网友评论