Reviewing a fastq_mergepairs rep

信息来源https://www.drive5.com/usearch/manual/merge_report.html

Below is an example report produced by the -report option of fastq_mergepairs. This information is also shown on the terminal (standard error output stream). The options -fastq_minmergelen 230 -fastq_maxmergelen 270 were used because these are 2 x 250 reads of amplicons generated by three different primer pairs including V4, V3-V4 and V4-V5. Using the length range 230 to 270 selects the V4 reads.

For each parameter used in pre-processing, alignment, merging and filtering the report shows how many pairs were successfully processed or discarded. The parameter value is also shown. For example, 7.9M reads (58%) were discarded because the alignment had >5 mismatches (parameter set by the fastq_maxdiffs option).

Here we have long overlaps, shown by the mean alignment length of 248. Mis-alignments are therefore very unlikely, and it would be reasonable to increase the -fastq_maxdiffs and -fastq_maxdiffspct values to increase the number of merged pairs. Quality filtering will take care of discarding reads where many mismatches induce a large number of expected errors. This doesn't necessarily happen -- e.g., if low quality base calls in R2 are mismatches against high-quality base calls in R1 then the merged Q scores can still be high.

If you think that too many reads are being discarded, then you can use the tabbedout file to investigate further.