You Drive Your Own Life 20200103

I woke up about 4:00 this morning, I didn't had breakfast, and went to the office directly after washing.

I prepared the meeting contents for the Skype meeting with R&D center. we discussed the material preparation status for M30&X61:

For M30, we can started to produce the top 11 part numbers after we get the updated BOM, but we can't start mass production until we get enough material of the 060134, and also we can switch 060132 with 060134 freely.

For X61, we still wait the reply from Germany Hason, one kind of resin that we used for this formula. meanwhile HT asked us to remix X61 with the worst resin we should produced the D465A with this mix and then we should run J2521.

we also talked about the noise issue of the M26&M98, HT asked us to set 35-45 as the HOGAN spec, but we can't meet this spec, so we discussed this problem, and finally we still set 20-50 as the spec, but we should do our best to adjust the parameters to meet the target 35-45.

they think the high GOGAN should be the key factor for noise.